宏旭定制  水泥縫隙式排水槽模具  縫隙式排水溝模具

 縫隙式排水溝模具  縫隙式水溝模具的支撐設施就是筋板，使用它能夠讓模具產品的整體性提高，而使用的鋼筋也應該符合金屬支撐的要求，鋼材質的質量要達到使用標準，而其中一些結構已經被破壞，或者表面出現銹濁的原來是不能在生產模具的時候使用的?？p隙式排水溝模具  縫隙式水溝模具的鋼面板厚度不能小于三毫米，而且表面要光滑沒有瑕疵，不能有皺折或者坑洼，安裝的時候要按照設計圖紙進行拼接，縫隙要做到嚴密，鋼面板要都經過矯正處理以后才能使用，在組裝的時候應該使用臨時的固定零件，避免會發生變形，而切割好的鋼面板要經過打磨拋光，嚴格遵循相關的規定?？p隙式排水溝模具  縫隙式水溝模具每次使用前或者使用后都會經過清洗，主要是為了避免生銹，也是為了讓工人拆模的時候更加便利，這種鋼模板要使用防銹劑進行保護，保護其在不使用的時候也能保持好的狀態，不會發生生銹而讓模具的尺寸受到影響，如果上面有油污或者灰塵要及時進行清除。

The support facility of slit type drainage ditch mold is rib plate. Using it can improve the integrity of the mold products, and the steel bars used should also meet the requirements of metal support. The quality of steel materials should meet the use standards. However, some of the structures have been damaged or the surface is rusty, which can not be used in the production of molds. Slit type drain mould The thickness of steel panel of slit type ditch mould shall not be less than 3mm, and the surface shall be smooth without defects, wrinkles or potholes. During installation, splicing shall be carried out according to the design drawings. The gap shall be tight. The steel panel shall be used after correction. Temporary fixed parts shall be used during assembly to avoid deformation and cut well The steel panel shall be polished and polished in strict accordance with relevant regulations. Slit type drain mould The slit type ditch mold will be cleaned before or after each use, mainly to avoid rust, but also to make it more convenient for workers to remove the mold. This kind of steel formwork should be protected with antirust agent to protect it from rust when it is not in use, so that the size of the mold will not be affected due to rust. If there is oil or dust on it Remove in time.