井體鋼模具  預制井體鋼模具平常要怎么清洗呢?先是模具表面灰塵的清掃:用干凈的抹布抹完之后，用手摸模具表面，如果感覺不到有灰塵的話，那么就是合格。沖孔部位的清掃:用錘子把孔內的廢料還有滑料板上粘著的廢料和刃口部位切廢料的殘屑全部清除掉。有鍍層的模具，必須對井體鋼模具  預制井體鋼模具的拉伸表面進行清掃，必須用手來確認表面是否光潔，生產時的材料必須用抹布抹干凈，生產后，必須給模具涂上少許的油。還有就是裝模前要對模具的上下表面進行清擦，保證模具安裝面和壓機工作臺面不受壓傷及模具在生產中上下安裝面的平行度。井體鋼模具  預制井體鋼模具裝好后將模具打開，將模具各部分清擦干凈，特別是導向機構，對于表面件模具，其型面清擦干凈，以保證制件的質量，這就是有關模具的平時的清洗地介紹。Specializing in the production of prefabricated well body mold, well body mold, well body steel mold, prefabricated well body steel mold, concrete well body mold, concrete well body steel mold, subgrade side ditch cover plate plastic mold, tile plastic mold and other plastic molds and steel molds. How to clean the prefabricated well steel mould? First, clean the dust on the mold surface: after wiping with a clean rag, touch the mold surface with your hand. If you don't feel dust, it is qualified. Cleaning of punching part: use a hammer to remove all the waste in the hole, the waste adhered to the sliding plate and the debris of cutting waste at the cutting edge. For the coated mold, the tensile surface of the prefabricated well steel mold must be cleaned, and the surface must be confirmed by hand. The materials during production must be wiped clean with a rag. After production, the mold must be coated with a little oil. In addition, the upper and lower surfaces of the die shall be cleaned before die installation to ensure that the die installation surface and the working table of the press are not under pressure and damage the parallelism of the upper and lower installation surfaces of the die in production. Prefabrication of well body steel mold after the well body steel mold is installed, open the mold and clean all parts of the mold, especially the guide mechanism. For the surface mold, the profile surface is cleaned to ensure the quality of the parts. This is the introduction of the usual cleaning place of the mold