其他定制尺寸，請聯系客服

鐵路分水槽模具在制作的時候?qū)τ谀酀{的需求量是非常大的，只靠工人進行泥漿攪拌的話會比較的麻煩，排水溝鋼模具，排水溝模具，鐵路排水溝模具定制 也不能夠保證泥漿的攪拌時均勻的，所以很多時候使用泥漿攪拌機更加的合適，之后將攪拌好的水泥慢慢的澆筑進鐵路分水槽模具里面，然后將模具統一放在震動平臺上進行加工處理，經過平臺的不斷震動，可以明顯的看到水泥表面有氣泡不斷的冒出來，一般體積較大一些的鐵路分水槽模具的震動時間可以控制在三分鐘左右，體積小一些的模具在一分鐘左右就可以了。然后將模具放在通風的環境中進行風干晾曬，在晾曬的時候需要經常在水泥的表面灑上一些清水，保證泥漿表面的濕潤，如果出現干裂的情況是不能夠正常使用的，另外在脫模之后需要將流水槽預制件也要噴上一些清水才可以，之后將鐵路分水槽模具清理存放。。The demand for mud during the production of the mold of the railway distribution tank is very large. It will be troublesome to only rely on the workers for mud mixing. The customization of the steel mold of the drainage ditch, the mold of the drainage ditch and the mold of the railway drainage ditch can not ensure the uniform mixing of the mud, so it is more appropriate to use the mud mixer in many cases, After that, the mixed cement is slowly poured into the mold of the railway water distribution tank, and then the mold is uniformly placed on the vibration platform for processing. After the continuous vibration of the platform, it is obvious that bubbles are constantly emerging on the cement surface. Generally, the vibration time of the mold of the railway water distribution tank with larger volume can be controlled at about three minutes, A smaller mold can be used in about a minute. Then put the mold in a ventilated environment for air drying. When drying, it is necessary to often sprinkle some clean water on the cement surface to ensure the wetting of the mud surface. If there is a dry crack, it can not be used normally. In addition, after demoulding, it is necessary to spray some clean water on the prefabricated parts of the water tank, and then clean and store the mold of the railway water distribution tank..