Potato refining and separating m achine is a kind of starch processing equipment, which takes fresh potato and dried potato as m ain raw m aterials and processes these raw m aterials into starch. It can complete three processes of crushing, refining and separating at one time. The m achine has s i m p l e structure, convenient operation, labor-saving and labor-saving. It is an ideal starch processing equipment.

Shengtai brand fresh potato starch m achine adopts the sawtooth type toothed roller. The fresh potato will be sliced into fine fila ments through the high-speed rotating toothed roller, which has less slag and does not block the filter screen, which is conducive to the extraction of starch. At the sa me time, the teeth are sharp and wear-resistant, which ensures the continuity of operation. The special separating device of starch m achine m akes the shredded potato go through two times of water washing, so that the starch and the powder residue have enough time to separate, so as to improve the extraction rate of starch.

The operators can only work after m astering the perform ance, mechanical structure and operation rules of the equipment. In case of equipment failure during operation, the following repair and m aintenance measures shall be taken:

1. When using the separator, the disc clearance should be adjusted to about 0.5mm. During operation, the upper handle should be screwed tightly, and then it can be backed back 90 degrees. If the m ain shaft of the crushing separation and pulp separator collides, the m achine should be stopped for inspection immediately. If the bearing is da m aged, the bearing of the sa me type should be replaced in time; the pulverizing unit works If it is found that the a mmeter of the crushing separator is overloaded for a long time, the feeding a mount of the cleaning m achine should be adjusted.

Special attention is: Planer separator and grinding separator must strictly prevent iron and stone and other hard debris into the m achine, so as to avoid da m age to m achine parts.

2. Main points for m aintenance and repair of the whole m achine: lubricating oil and grease should be added to the drive bearings of sm all potato milling equipment, especially the oil cups at both ends of the m ain shaft of the grinding separator and the planer separator. Calcium based grease should be added once every 48 hours of operation, and the whole m achine should be m aintained regularly once a month;

All electrical equipment and driving belts on the single m achine of pulverizing unit shall not be wet or watered, so as to avoid short circuit or belt slipping accident; if the transmission belt is found to be slipping, the belt wheel gauge shall be adjusted in time to m ake the belt tight; the wire mesh under the screw of the cleaning m achine is easy to be da m aged after a certain period of time, and it shall be renewed after processing 500000 kg of fresh potatoes; the rack of the device on the shaving drum is used to m ake the belt tight After using for a period of time, if it is found that the production efficiency decreases and the powder slag becomes coarse, the rack should be removed and replaced with a new tooth on the other side for continuous use; after the potato flour milling unit is out of service, the whole m achine should be repaired and m aintained, and the bearing should be cleaned and filled with lubricating oil and grease. All electrical equipment should be provided with moisture-proof measures to avoid affecting the perform ance and service life of the equipment.